My ceFIRO

[doraemon98]

Bros weikee, My A32 3.0 also facing the same problem a/c compressor dont cut off also went i put into 32c. Some ac mechanic told me my A32 ac intake sensor missing?

My A33 a/c compressor also never cut. TCESC told me A33 was built that way. It cuts when u floor the accelerator. Can anyone confirm this?

 

[weikee]

Most Nissan ecu will cut the A/C compressor when you rev the engine and also when is overheat, this is to protect the a/c compressor when engine is revving high, and give more cooling capacity to the radiator / engine when overheat detected.

It will cut in climate control but not so frequent. Climate control a/c system use hot air "from radiator water" mix with cold air "from A/C cooling coil" to control / reach the temperate driver set. Is difference from the normal A/C in the car, where you feel a sudden cold then not cold then cold again.

I heard there are new type of climate control system, but did not really go into detail which car have it or how it work.

 

[doraemon98]

Ya the a/c compressor never cut even put it to 32C unless depress the a/c button on the control.

I never do any service on the a/c system for the past 7 years. Is it necessary to do any preventive maintenance on it?

 

[weikee]

It actually will cut, just you don't notice cause is a rotary pump.

I do a/c cleaning / service every 2 years. If A33 come with filter in the blower than the maintenance can be later.

BTW, i go KL -> Ipoh -> Penang -> Ipoh -> KL, total mileage around 800km+, only use around 80 Liter petrol. I can go better if i did not speed to 140 / 150km/h

 

[doraemon98]

It actually will cut, just you don't notice cause is a rotary pump.

I do a/c cleaning / service every 2 years. If A33 come with filter in the blower than the maintenance can be later.

BTW, i go KL -> Ipoh -> Penang -> Ipoh -> KL, total mileage around 800km+, only use around 80 Liter petrol. I can go better if i did not speed to 140 / 150km/h

I can notice if the pump cut because I can feels it vibrate a little on the steering. I cannot feel any vibration on steering with the a/c off. Of course with the car idle.

I never experience the a/c pump cut on a traffic jam even at night nor set it to 32C with only hot air blowing.

Your a32 fc is very good. The most I got is 9.5l/100km on mostly highway at 110km/hr speed. Notice shell ron95 can go further compare to esso.

 

[weikee]

I switch back to 97, Ron 95 is like pulling cow.

 

[sb3]

hey SB3
i have on 20's right now and adjustable d2 shocka dn soring coilovers....but the car once lowered to the tired height or even a little higher still causes the joints to fail...i dnt knw if the symetry of the vehicle is off but i see a lot of these lowered very low all over the net i was wondering if there is a shorter axle or better bigger cv joint ppl use...

When you mention changing cv joints do you change the whole cv joints and the driveshaft coz I suspect your driveshaft is bent... try to get the whole set (driveshaft plus cv joints) and see what happens. In your country , do you have wreckers shop whereby they sells secondhand auto parts from japan ?

 

[seizai]

change new part

 

[xxx2299]

change new part

you changed part, i changed car

now driving ACV30

A33 still waiting for new owner, siapa mau beli?

 

[whatzzzup]

hello there...any owners of A33 converted to 2.5 NEO??????

 

[chteo]

hi seizai, is that from eagle eye TW?

mine's getting dimmer as well, but am planning to mod to projector lens for a change...

change new part

 

[seizai]

hi seizai, is that from eagle eye TW?

mine's getting dimmer as well, but am planning to mod to projector lens for a change...

brand is stated at box...

I was thinking about tat.. but can't fit in hid... takut saman

 

[chteo]

brand is stated at box...

I was thinking about tat.. but can't fit in hid... takut saman

haha, yea, it came across my mind too, but then again i'd go for safety first rather than having dim lights.

i'll post up some pics after i got mine done...

 

[seizai]

projector... better get single type, not d hi/lo type, much clear & bright.

 

[chteo]

seizai, am getting the pj3 bi-xenon with 40W 4300k HID, seen the performance, great for my night travellings on PLUS....

 

[seizai]

seizai, am getting the pj3 bi-xenon with 40W 4300k HID, seen the performance, great for my night travellings on PLUS....

HID std should be 35W, r u sure it is 40W?

 

[chteo]

HID std should be 35W, r u sure it is 40W?

yup, saw the ballast with my own eyes, comes with 1 year warranty, should be ok, since there are so many guinea pigs out there using it already....

 

[seizai]

any brake pad recommend for ori pot?

 

[Lean]

Bendix Metal King Pro but it gives a lot of carbons but provides a better braking.

Soft Brakes = Better Braking but more Carbon released by it
Hard Brakes = Somehow good but less Carbon released by it

Correct me if I'm wrong yeah.

 

[seizai]

http://img12.imageshack.us/img12/1778/20120202231215.jpg
http://img515.imageshack.us/img515/464/20120202231035.jpg
http://img526.imageshack.us/img526/6919/20120202230836.jpg
http://img40.imageshack.us/img40/8373/20120202230814.jpg

is this model correct for 3.0 1st batch?