Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="raybakh" data-source="post: 1466860" data-attributes="member: 3251">mine is another case, last time got overheat,so my mech check and check and found out that the thermostat is faulty. So, he throw the the thermostat out and now the car is running w/o thermostat. It keep the engine cooler as water are running the block everytime unlike using thermostat when only temp rise does the thermostat give way for water to run around. Never had my temp needle more than half even during jam.</blockquote>

Verification

The Marketplace Latest

R35 GTR 2020 Original Rim Wheels
- Started by aycy
- Chassis and Wheels
Greddy Trust R35 Y Pipe GTR GTR35 Exhaust Used
- Started by aycy
- Exterior and Body
Nissan Silvia S15 Door Trim Card Panel Bride
- Started by aycy
- Interior and Cockpit
Atlas Force UHP Used Tire Tyre 275 35 20
- Started by aycy
- Chassis and Wheels
R35 GTR Ohlins Adjustable Suspension
- Started by aycy
- Chassis and Wheels
Nismo LMGT4 40th Anniversary 18x9.5+12 White
- Started by aycy
- Chassis and Wheels
Rays G025 18 inch VW Audi S3 A45 CLA45 Golf MK7 MK8 Rim
- Started by aycy
- Chassis and Wheels
S13 S14 S15 Used Drift Rim Tire Set
- Started by aycy
- Chassis and Wheels
R35 Used Titanium Exhaust
- Started by aycy
- Engine and Performance
PWR FL5 / FK8 Street Radiator 42MM
- Started by aycy
- Engine and Performance

Posts refresh every 5 minutes

Mahle, CP piston

MAHLE & CP piston, anyone heard of it or using it? Comment?

Or beside this 2 brand, any other brand with the price range almost same with the 2 piston brand i mentioned above.

I want to change Turbo sleeve to ball bearing

hi, if i want to change TD04 to Garrett GT25,

is it just plug out and install back?

anyway i don't think so!!
what do i need to change? custom header again?
what is the cost? any workshop want to quote to me by PM...

2" mid pipe or 2.5" mid pipe, with cat or cat-less

Hi all
Which would be a better choice for my Swift 1.5 AT with BOT, 2" mid pipe or 2.5" mid pipe?
Is it adviseable to run cat-less or with cat?
Stock mid pipe @ 1.7"
Thanks!