Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="nappx" data-source="post: 1063558221" data-attributes="member: 17729">normal reading based on my bt engine (NA)morning - engine cold..first start the needle can up until 4.6 - 4.8 x100kpa (Pivot gauge) then after few minute the pressure start going down until 2.0 - 2.2 kpawhen high rev..it recorded 5.2-5.3 kpa.after long high rev when stop (idling..sometime the pressure can drop 1.8-1.6 kpa..it depend you on or off aircond..based on what i'm understand..if the oil in high temperature can drop until that 1.8-1.6kpa..then later back to normal pressure 2.0-2.2 kpa...p/s:- this reading based on pivot gauge & it also depand on oil engine if i not mistake..</blockquote>

Verification

The Marketplace Latest

R35 GTR 2020 Original Rim Wheels
- Started by aycy
- Chassis and Wheels
Greddy Trust R35 Y Pipe GTR GTR35 Exhaust Used
- Started by aycy
- Exterior and Body
Nissan Silvia S15 Door Trim Card Panel Bride
- Started by aycy
- Interior and Cockpit
Atlas Force UHP Used Tire Tyre 275 35 20
- Started by aycy
- Chassis and Wheels
R35 GTR Ohlins Adjustable Suspension
- Started by aycy
- Chassis and Wheels
Nismo LMGT4 40th Anniversary 18x9.5+12 White
- Started by aycy
- Chassis and Wheels
Rays G025 18 inch VW Audi S3 A45 CLA45 Golf MK7 MK8 Rim
- Started by aycy
- Chassis and Wheels
S13 S14 S15 Used Drift Rim Tire Set
- Started by aycy
- Chassis and Wheels
R35 Used Titanium Exhaust
- Started by aycy
- Engine and Performance
PWR FL5 / FK8 Street Radiator 42MM
- Started by aycy
- Engine and Performance

Posts refresh every 5 minutes

Boost Meter - Digital or analog ?

For Evo boost meter, use digital (greddy) or Analog type(Defi) ?
What the advantages and disadvantages for both type ?

Unique wireframe installation kicks start Range Rover Evoque campaign in Malaysia

Land Rover Malaysia has just launched the marketing campaign that will precede the launch of the acclaimed Range Rover Evoque in the fourth quarter of the year with a unique life-sized wireframe installation that...

Going Nismo Omori. Need anything Nismo?

Is time of the year again, im going to Nismo Omori in Shinagawa,
The place where the Ztune is made.

If you need any emblems or badges i can get them for you .

call me and hand me the MONEY ! at the gathering this...