Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="CelicaIzPower" data-source="post: 1178239" data-attributes="member: 21486">dear all,after much check here and there. i've found that the bolt for the air filter (new and installed at brothers) was too high and it hits the stabilizer bar thus making the carb slightly presurred where effects the throthle pull back thing (where the throthle cable is being pull at) so the solution is 1.> cut the nut so that it will be slightly lower.2.> service the carb (since too much unwanted stuff fell in when brothers fitting in the air filter element.3.> need to retune the distributor to setup the plug burst time.anyway thanks for all your comments.. it really make me look at alternatives.</blockquote>

Verification

The Marketplace Latest

Perodua Bezza body kit/spoiler
- Started by jeff6126
- Exterior and Body
Honda Jazz FLRS side skirt
- Started by jeff6126
- Exterior and Body
yellowcaliper /caliperspray
- Started by jeff6126
- Exterior and Body
Te37 Track Edition 2 FK8 FL8 Civic Type R Rim Wheel...
- Started by aycy
- Chassis and Wheels
Revozport R35 GT Wing Spoiler and Trunk
- Started by aycy
- Chassis and Wheels
original rare Work Emotion 11R 18x8.5jj offset +47...
- Started by david tao
- Chassis and Wheels
Spoon FK8 FL5 19 inch rim wheel Type R
- Started by aycy
- Chassis and Wheels
Litchfield GTR R35 Road Suspension Kit Absorber
- Started by aycy
- Chassis and Wheels
original rare Yokohama ADVAN Racing RG3 18x8.5jj...
- Started by david tao
- Chassis and Wheels
~accident repair ~touch up paint
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

looking e6 original actuator or exchange with me

guys, mine actuator is over 1.3 bar i m looking for ori e6 act or someone wanna exchange with me !!

is e6 if u have the item for sale or exchange do let me know 0123709020 ken

WTS: Evo 8 bumper

I have a original stock evo 8 bumper for sale ,

RM 850.00

pls refer to the attached picture for reference...

Shifting Rod

is it recommended to cut the shift rod shorter so tht it looks "sporty"? Will it affect the shifting procedures???

btw, is there any custom shortshift makers in malacca?

thanks in advance...
hehe
:)