Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="johnsonlam" data-source="post: 1064381425" data-attributes="member: 345">Was walking about Low Yatt and saw some good offer for Neon Lights. 70% off :D This DIY can be argued to be Ah Beng or as a cool decoration.. but whatever it is... :P as long as we are happy can liau la.. http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons001.jpgThese are standard PC neons.. This is from Cooler Master. Since I did not modify my computer ever since busy working with company notebooks.http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons002.jpgAs this was for PC, there is a controller box with a PC back panel... Simple.. I took the panel out by removing the 2 screws.. and I bang them using a hammer and install it back (Steps not shown).. NOTE : do not bang them with the PCB circuit on to avoid breaking it.http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons003.jpgI am pulling the power from the wiring to Ciggrette LIghter Socket... Removing the panels to it is soooo simple because I already learnt it the hard way from my DIY-AUX Input tragedy.. hahah.. Just need to remove 2 screws.. the rest are just SNaped ON.http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons004.jpgTrial Run after I strap it on.... Okie.. looked good.ahem... the hard part of the installation wasn't shown here.. that is to have the main Neon ballast to be nested behind the dash... and the 2 wirings to the neons pushed thru.... http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons005.jpgThis is almost the part where it is almost completed.. You can see that I have removed the sound proofing to enable me to TIE the neons on it. The controller is seen here.. dangling.. not fasten down yet.http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons006.jpgSound proofing installed to the original position, The controller also fastened using Double Sided tape.http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons007.jpgPicture showing passenger side's neonhttp://forum.lancerzone.com/gallery/albums/userpics/10800/Neons008.jpgThe controller box looked too.. revealing as it was Silver in colour.. Should have sprayed it first... so I "Stealth" it by adding Black Matt Stickers...http://forum.lancerzone.com/gallery/albums/userpics/10800/Neons009.jpgDONE... looked not so obvious now.. hahahahttp://forum.lancerzone.com/gallery/albums/userpics/10800/Neons010.jpgCheck out the video of it working and blink syncing with music. [youtube]QZ1cboouECc[/youtube]</blockquote>

Verification

The Marketplace Latest

R35 GTR 2020 Original Rim Wheels
- Started by aycy
- Chassis and Wheels
Greddy Trust R35 Y Pipe GTR GTR35 Exhaust Used
- Started by aycy
- Exterior and Body
Nissan Silvia S15 Door Trim Card Panel Bride
- Started by aycy
- Interior and Cockpit
Atlas Force UHP Used Tire Tyre 275 35 20
- Started by aycy
- Chassis and Wheels
R35 GTR Ohlins Adjustable Suspension
- Started by aycy
- Chassis and Wheels
Nismo LMGT4 40th Anniversary 18x9.5+12 White
- Started by aycy
- Chassis and Wheels
Rays G025 18 inch VW Audi S3 A45 CLA45 Golf MK7 MK8 Rim
- Started by aycy
- Chassis and Wheels
S13 S14 S15 Used Drift Rim Tire Set
- Started by aycy
- Chassis and Wheels
R35 Used Titanium Exhaust
- Started by aycy
- Engine and Performance
PWR FL5 / FK8 Street Radiator 42MM
- Started by aycy
- Engine and Performance

Posts refresh every 5 minutes

Airtrek member in Ipoh

Any Airtrek member are from Ipoh.

A Flaming Lamborghini - Damansara Heights

The Green Flamingardo that made the headlines just last week. Pitiful business owner took his bull for a spin...

2009 Ferrari F70 Preview

http://pictures.topspeed.com/IMG/crop-460x187/_Ferrari_F70_main2_2w.jpg

In 1995 Ferrari launched the F50. Seven years after that it was replaced by the Enzo. And now, according to a rule that Ferrari always follow...