Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="skylee834" data-source="post: 3092748" data-attributes="member: 60392">bro,buy a TEin from chop shop lah,1 set about Rm1600.(like new one).GAB r cheaper but hear not so good response from user,very hard the spring,unless u get soft hard Hi Low adjustable one....try to change out the bushes at all..front lower arm,steering rack bush etc,will make a big different.i using front lower Arm/rear lower arm. from EVO3,already change out the control feeling...try it..:wavey:</blockquote>

Verification

The Marketplace Latest

R35 GTR 2020 Original Rim Wheels
- Started by aycy
- Chassis and Wheels
Greddy Trust R35 Y Pipe GTR GTR35 Exhaust Used
- Started by aycy
- Exterior and Body
Nissan Silvia S15 Door Trim Card Panel Bride
- Started by aycy
- Interior and Cockpit
Atlas Force UHP Used Tire Tyre 275 35 20
- Started by aycy
- Chassis and Wheels
R35 GTR Ohlins Adjustable Suspension
- Started by aycy
- Chassis and Wheels
Nismo LMGT4 40th Anniversary 18x9.5+12 White
- Started by aycy
- Chassis and Wheels
Rays G025 18 inch VW Audi S3 A45 CLA45 Golf MK7 MK8 Rim
- Started by aycy
- Chassis and Wheels
S13 S14 S15 Used Drift Rim Tire Set
- Started by aycy
- Chassis and Wheels
R35 Used Titanium Exhaust
- Started by aycy
- Engine and Performance
PWR FL5 / FK8 Street Radiator 42MM
- Started by aycy
- Engine and Performance

Posts refresh every 5 minutes

Your experience with Airtrek...

Not many Airtrekers come here anymore. I thought I should start a thread about writing how you feel about your Airtrek or ex-Airtrek (if you have sold yours)... do share your experience and ownership.

WTB used Fairlady 350Z .. 04 above..

Hi guys, i m serious buyer and i m looking good condition Nissan Fairlady 350z...
anyone who wanna upgrade their 350z to other car, can please offer to me... dont worry i take good care of your ride ..kekeke...

EP82 turbine help

Anybody knows what's the minimum boost for the Toyota Starlet EP82 turbine? Going to use it for a bolt on turbo project.. Was wondering if the actuator could leak out to get around 0.3-0.4 bar only..

Help me out...