Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="phat7" data-source="post: 729776" data-attributes="member: 3001">morning jason,Buy the original front end ,trust me its worth the money.I have yet to come accross replica front end here in Malaysia but the quality is questionable. It does a bad job holding up woth scrapes and bumps. You're looking at approximately 1.6k for the bumper skin. Its very hard to find the 99 spec rear reinforcement bar which direclt bolts on, but alternatively you can cut up your existing rebar and retrofit. The bumper lights (identified by "stanley" markeings on persplex) would set you back about 1.5k. I personally prefer the replica as there is a 3d cuts in the light housing. You can get the replica's for bout 1.2k.</blockquote>

Verification

The Marketplace Latest

R35 GTR 2020 Original Rim Wheels
- Started by aycy
- Chassis and Wheels
Greddy Trust R35 Y Pipe GTR GTR35 Exhaust Used
- Started by aycy
- Exterior and Body
Nissan Silvia S15 Door Trim Card Panel Bride
- Started by aycy
- Interior and Cockpit
Atlas Force UHP Used Tire Tyre 275 35 20
- Started by aycy
- Chassis and Wheels
R35 GTR Ohlins Adjustable Suspension
- Started by aycy
- Chassis and Wheels
Nismo LMGT4 40th Anniversary 18x9.5+12 White
- Started by aycy
- Chassis and Wheels
Rays G025 18 inch VW Audi S3 A45 CLA45 Golf MK7 MK8 Rim
- Started by aycy
- Chassis and Wheels
S13 S14 S15 Used Drift Rim Tire Set
- Started by aycy
- Chassis and Wheels
R35 Used Titanium Exhaust
- Started by aycy
- Engine and Performance
PWR FL5 / FK8 Street Radiator 42MM
- Started by aycy
- Engine and Performance

Posts refresh every 5 minutes

Questions about Cedia

Hi guys,

I am looking at cedia 2002 MX-E model(1500cc) which has GDI with CVT and probably 4wd?

I've been searching on the internet about the model and some people said

The GDi engine has some issues. Is that...

Dome light DIY 3 Wires to 2 wire

My altis original dome light got three wire i buy the new dome light only have two wire.
how can i install it??
how to install any one can teach me?

Seimens+bolt on+Unichip ?

Good day to the Fellowship of Turborians!

I am currently having this problem with my car, here are the details

Engine : 4g13 + Bolt on Turbo (TD025)
Ecu : Seimens + Unichip (piggy back system)
Additional Support ...